What Broward County Homeowners Actually Pay
Broward County sits inside the HVHZ along with Miami-Dade, so the same hardware and gauge standards apply. We install .032″ minimum aluminum as standard and .040″ on long, exposed runs. Broward mixes older single-story neighborhoods, canal and waterfront homes with salt-air exposure, and large planned communities with two-story homes, which is why roof edge length and hardware choices differ so much from home to home.
For seamless aluminum, expect about $7–$12 per linear foot installed, which is roughly $1,050–$1,800 for a 150-foot home. Most full-home projects land between $1,000 and $3,500.
Cost by Gutter Type in Broward County
| Gutter Type | Cost per Linear Ft. (Installed) | Typical Total — 150 Linear Ft. Home |
|---|---|---|
| Seamless aluminum, 5″ K-style, .032″ | $7 – $10 | $1,050 – $1,500 |
| Seamless aluminum, 6″ K-style, .032″ | $9 – $12 | $1,350 – $1,800 |
| Heavier .040″ gauge for exposed runs (adds about $2–$3 per ft.) | $10 – $14 | $1,500 – $2,100 |
| Half-round aluminum | $10 – $16 | $1,500 – $2,400 |
| Copper, seamless | $25 – $40 | $3,750 – $6,000 |
We install .032″ minimum gauge as standard and step up to .040″ on long, exposed runs. The extra cost is modest compared with re-installing after storm damage.
Typical Cost by City in Broward County
The per-foot range is the same across the county; the typical home is what differs. A representative mid-size home in each city we serve, at $7–$12 per linear foot:
| City | Representative Home | Linear Feet | Typical Installed Total |
|---|---|---|---|
| Fort Lauderdale | a 1,800–2,600 sq ft home | 160–210 ft | $1,120 – $2,520 |
| Hollywood | a 1,600–2,200 sq ft home | 145–190 ft | $1,020 – $2,280 |
| Pembroke Pines | a two-story home of about 2,200–2,800 sq ft | 170–220 ft | $1,190 – $2,640 |
| Coral Springs | a 2,000–2,600 sq ft home | 160–210 ft | $1,120 – $2,520 |
| Pompano Beach | a 1,600–2,200 sq ft home | 140–185 ft | $980 – $2,220 |
Add-ons are priced separately: extra downspouts run about $45–$75 each, gutter guards about $3–$12 per linear foot, and repairing a damaged section of fascia commonly $200–$600. On flat Broward lots with a high water table, a downspout that spills at the slab leaves water nowhere to go; buried lines to a pop-up emitter or dry well carry it clear.
Permits and Licensing in Broward County
Broward generally does not require a separate permit to add gutters to a standard single-family (R-3) home with an eave height of 30 feet or less, unless the gutter is installed behind the drip edge, which needs plan review. Gutters installed with a roof replacement fall under that roofing permit.
Gutters for New Construction Homes in Broward County
Broward has many planned communities and active infill. New homes and townhomes sit on compact lots, and builders do not always include gutters, so owners commonly add them later. HOA rules often govern gutter color and downspout placement. Where a builder does offer gutters, ask which elevations are covered, the gutter size and where the downspouts discharge. On zero-lot-line and small-lot designs, check local rules and HOA requirements before choosing where roof water goes. Installing before landscaping and pavers are finished is the cheapest time to add downspouts and drain lines.
Broward County Gutter Cost FAQ
How much does gutter installation cost in Broward County?
About $7–$12 per linear foot for seamless aluminum, or roughly $1,050–$1,800 for a 150-foot home. Most full-home installations in Broward County fall between $1,000 and $3,500, depending on roof size, gutter size, downspout count and fascia condition.
Does Broward require a permit for gutters?
Generally not for a standard single-family (R-3) home with eaves 30 feet or lower, unless the gutter is installed behind the drip edge. Gutters installed as part of a re-roof fall under the roofing permit.
Do new construction homes in Broward County come with gutters?
Often not on every side. Many builders treat gutters as an optional add-on, so owners commonly add them after closing, ideally before landscaping and pavers go in.
Are 6-inch gutters worth it in Broward County?
They can be. 6-inch gutters cost roughly $2 more per foot and carry more water, which helps on large or steep roofs and long runs that drain to one downspout. We size from roof area and pitch.
"Every county we work in has its own quirks on permitting and product standards. We keep track of them so you don't have to — the quote we give you in Broward County already accounts for what your specific jurisdiction requires."
Get a Straight Answer
Tell us what's going on — we'll give you honest guidance on cost and what's realistic. No obligation.
Got it — thank you!
A D&Co Homes Project Manager will reach out to you shortly with next steps for your property.